No-Sew Ribbon Belt

Stuff You Need:

• One-inch-wide cloth ribbon in your favorite color. The ribbon length should be twice your waist or hip measurement (depending on where you wear your pants) plus an extra 12 inches.• D-ring belt buckle the same width as your ribbon. D-rings are d-shaped metal rings that can be used to fasten belts and straps. You will need two rings for one belt.

Directions:

1) Thread the ribbon through two rings and slide the rings to the center of the ribbon.

2) Fold the ribbon over the flat side of the rings so that ends of ribbon meet.

3) Keeping the two sides of the ribbon together, tie a half-knot about six inches in from the end of the ribbon.

4) To wear, thread the knotted end of the belt through your belt loops, keeping the buckle end in front. Pass the ribbon end through both D-rings, then fold it over the inside ring and pass it back under the outside ring. Tuck ends of ribbon into your belt loop, or let them hang free.